Products
Why EMS Uses a Mustang Dyno
Unlike inertia dynos that can inflate numbers, the Mustang MD-AWD-1100 is a true load-bearing dynamometer. It applies controlled vehicle loading to simulate real road conditions—making tuning safer, repeatable, and meaningful.
- ✔ Real-world loading for accurate results
- ✔ Repeatable before/after comparisons
- ✔ Better control for turbo/supercharged tuning
- ✔ Ideal for AWD torque balancing and drivetrain testing
AWD & 2WD
Test AWD vehicles or run 2WD mode as needed
Load-Based Control
Precise control over RPM, load, and sweep profiles
Performance Validation
Verify upgrades with consistent before/after runs
MD-AWD-1100 Series Specifications
| Max Power |
AWD: up to 3,500 HP
2WD: up to 2,500 HP
|
|---|---|
| Top Speed |
AWD: up to 175 mph
2WD: up to 225 mph
|
| Roller Configuration |
Rear rollers: 30 inch
Front rollers: 12.625 inch
|
| Maximum Axle Weight | 10,000 lbs |
| Wheelbase Range | 80 – 134 inches |
Hole Shot™ Control & Data
Our dyno runs on Mustang Hole Shot™ software for professional testing, monitoring, and reporting.
- ✔ Real-time horsepower & torque graphs
- ✔ Load-based tuning (not just WOT pulls)
- ✔ Before/after comparisons and printable reports
- ✔ Ideal for gear-by-gear ECU calibration
Real Numbers. Real Results.
Book a dyno session and get accurate, repeatable measurements with load-based tuning.
Book Dyno Session